Foam Tapes

Pres-On U6200 Series Urethane Foam Tapes are high density, open cell, urethane foam tapes with a double side coating of high-tack acrylic adhesive. These foam tapes exhibit excellent cushioning characteristics and apply easily to most clean, dry surfaces – even irregular rough surfaces. U6200 reduces the transmission of vibration, provides thermal insulation, and offers excellent mounting and holding strength.

Pres-On

Products Details

  • Tech Specs
  • Product Highlights
  • Applications
  • Available Options

Standard Roll SizesSerial NumberThicknessLength
All rolls available in widths from 3/16” to 54”U62031/32”200'
U62061/16”100'
U62121/8"50'
Adhesion PropertiesTestTypical PerformanceMeasurement Method
Dynamic Tensile Bond90PSI
Dynamic Shear Adhesion (PSI) (180 peal adhesion stainless steel)95PSI
Liner Side100oz/in
Exposed Side85oz/in
Temperature-40 F to 200 Fdegrees F
Water and Humidity ResistanceExcellentPres-On
Shelf Life1 year stored at room temperature
Physical PropertiesPropertyTest MethodResult
Density (lbs/cu ft)ASTM D-88230 lbs
Hardness, Shore AASTM D-224028
Tensile Strength (PSI)ASTM D-882175
100% Modulus (PSI)ASTM D-88285
Elongation %ASTM D-882350
Thermal ConductivityRetention of tensile properties 2 weeks @ 185 F and 100% R.H.80% Minimum

  • High density, open cell, urethane foam tape
  • Coated with high tack acrylic adhesive on both sides
  • Uniform cell structure and excellent dimensional stability
  • Resists moisture, dust, and contaminants
  • Excellent compression set resistance
  • Low thermal conductivity, retards heat flow

Pres-On U6200 Series Urethane Foam Tapes are used for the mounting of interior signs, nameplates, wire clips, electrical channels to walls, air fresheners, soap dispensers, acoustic panels to walls, and provides vibration dampening for electronic components. These tapes can also be used in industrial assembly applications as an alternative to traditional fasteners.

  • Signage
  • Graphics
  • Exhibits & Kiosks
  • Wire Clips
  • Vibration / Noise Dampening
  • Electronic Equipment Components
  • Soap Dispensers
  • Air Fresheners
  • Acoustic Wall {anels
  • Nameplates

Application Notes

Thoroughly clean contact surface before use. Once tape has been applied, it cannot be removed and reused. Therefore, position tape carefully, assuring that it is in contact with all surfaces. If tape is misaligned, remove used unit, discard and repeat application with new unit. Test product for system compatibility as individual application conditions can impact results.

  • Release Liner: Brown Kraft Paper
  • Custom die-cut shapes